BP-200/205xei : 7.2v replacement insert for BP-200, BP-205 READY TO USE
BP-200/205xei : 7.2volt 2000mAh replacement Ni-MH insert for your Uniden BP-200 & BP-205 battery pack. Made with eneloop cells, which are LONG LIFE, rechargeable. and PRE-CHARGED & READY TO USE.
To rebuild, you will need to remove the 2 screws on the bottom side of your battery pack. Then the 2 black plastic halves of the battery can be Carefully pulled apart. The old insert will need to be de-soldered (to detach the 2 wires connected to it), and the new insert put in its place. You will need to Confirm Polarity when attaching wires. Typically, red wire is Positive, and goes to the Positive Tab. Typically, black wire is negative, and goes to the negative tab. You will need to insulate any exposed metal parts when completing the rebuild process, to insure integrity.
BP-200/205xei : 7.2volt 2000mAh replacement Ni-MH insert for your Uniden BP-200 & BP-205 battery pack. Made with eneloop cells, which are LONG LIFE, rechargeable. and PRE-CHARGED & READY TO USE.
To rebuild, you will need to remove the 2 screws on the bottom side of your battery pack. Then the 2 black plastic halves of the battery can be Carefully pulled apart. The old insert will need to be de-soldered (to detach the 2 wires connected to it), and the new insert put in its place. You will need to Confirm Polarity when attaching wires. Typically, red wire is Positive, and goes to the Positive Tab. Typically, black wire is negative, and goes to the negative tab. You will need to insulate any exposed metal parts when completing the rebuild process, to insure integrity.
Original: $49.95
-70%$49.95
$14.98Description
BP-200/205xei : 7.2volt 2000mAh replacement Ni-MH insert for your Uniden BP-200 & BP-205 battery pack. Made with eneloop cells, which are LONG LIFE, rechargeable. and PRE-CHARGED & READY TO USE.
To rebuild, you will need to remove the 2 screws on the bottom side of your battery pack. Then the 2 black plastic halves of the battery can be Carefully pulled apart. The old insert will need to be de-soldered (to detach the 2 wires connected to it), and the new insert put in its place. You will need to Confirm Polarity when attaching wires. Typically, red wire is Positive, and goes to the Positive Tab. Typically, black wire is negative, and goes to the negative tab. You will need to insulate any exposed metal parts when completing the rebuild process, to insure integrity.
